Oreck XLS465 User Manual download pdf (Page 5)

THE ONLY TOOL YOU WILL NEED IS A PHILLIPS-

TYPE SCREWDRIVER!

ASSEMBLY STEP ONE (Figure1):

Attach Handle to Cleaner

1. Lay the cleaner on a flat surface with the tank side

down or to its side.

2. Slide handle into cleaner body until interlock

is secured (Figure 1-A).

3. Insert four

⁄8” screws into the four cavities in

the handle base and tighten (Figure 1-B).

ASSEMBLY STEP TWO (Figure 2):

Attach Wheels

1. Locate two wheels and two support legs.

2. Insert the wheels (A) into the support legs (B) by

pushing the wheels in until they snap into place.

ASSEMBLY STEP THREE (Figures 3 and 4):

Attach Nozzle

1. Turn the unit so that the tank is face up.

2. Align the nozzle so the red nozzle change button

(Figure 3-A) is in line with the corresponding hole

in the nozzle (Figure 3-B).

3. Depress the small red nozzle change button

(Figure 3-A) and slide the nozzle over the unit

shaft until the button locks into place.

4. Plug the small power cord connected to the nozzle

(Figure 4-A) into the receptacle in the back of the

unit (Figure 4-B).

NOTE: Before using, please read the important

safety and operating instructions.

To Assemble Cleaner

Figure 1

Slide Handle forward

Figure 3

Figure 2

Figure 4

1 2 3 4 5 6 7 8 9 10 11

No comments

Oreck XLS465 User Manual Page 5